A typical project will be headed by an Architect or a Domain Specialist. He will be supported by a team of engineering specialists having different skill-sets which complements, and at times compete with each other.Read More
Theoretically, a structure is a system of connected parts used to support a load, and structural design is the application of fixed and repetitive mathematical formulae. In practice, it is not as simple as it seems.Read More
Electrical design and consultation is a specialist job and a demanding profession which requires skills, domain expertise and adequate understanding of governing rules and regulations like IEC & IER etc.Read More
Loss of life and property due to fire has the potential to break a business. Therefore,fire protection strategies must go beyond the ‘minimum requirements’ specified in the codes and standards.Read More
Contract administration is at the core of any successful project and programme management strategy which requires significant design intent, intimate knowledge of the project and continued support throughout the project life cycle.Read More
Estimating how much electricity to use is the starting point of any electrical design work and determines what type of input voltage (HT or LT) to use on a routine basis for an electrical installation.
At Besten, electrical design of any installation will start by preparing electrical load tables. This is done by listing down individual items which requires electricity and the power requirement of each item.
Our electrical designers study the layout of various loads and relative locations and systematically record the grouping of the loads together with operational demands and operating modes. From this data, the values like installed load, load factor, diversity factor, steady state demand, maximum demand, connected load etc is obtained.
The electrical load data together with information on local codes and tariff policies will help in deciding the type of incoming power connection (LT or HT) required for the project.
HT service connection requires the sizing and design of consumer side substation (Indoor/Outdoor), sizing of transformers & switching equipment and is metered under HT tariff.
LT installations are normally connected to the local network using proper isolation and protective equipment and metered under LT tariff.
Load Calculation ● Load Factor Calculations ● Diversity factor Calculations ● Maximum Demand Calculation ● Installed and Contract Load Calculation ● Electrical Installation Sizing ● Transformer Sizing ● Block Diagrams ● Block Estimates ● Primary Consultation Report